CHARACTERISTICSINTRASIT
® UT 18L is a liquid, chemically and physically acting universal release agent.
It does not reduce the adhesion of subsequent coatings.
High release effect due to low viscosity, even when thinly applied.
- Solvent-free
- Ready to use
- Sprayable
- Universal in use
- High yield
- Biodegradable
INGREDIENTSMineral oils, additives
USEINTRASIT
® UT 18L is used for treating virtually all types of formwork. For the protection and care of building machinery, in particular as a release agent for asphalt transport and conveyor vehicles. The adhesion of the hot asphalt is significantly reduced enabling better cleaning of the storage and conveyor surfaces.
Areas of application:
- Steel formwork, wooden formwork (including plasticcoated) and plastic formwork
- Heated formwork up to +180 °C
- Production of in-situ concrete and fair-faced concrete
- Precast concrete components
- Asphalt transport vehicles
PREPARATION OF THE SURFACEThe substrate must be clean and dry.
APPLICATIONGuidelines are DIN 1045 for concrete and reinforced concrete, DIN 18999 for concrete and mortar additives.
| 1. | Use a wide brush, rag or spraying device to apply a thin layer of INTRASIT® UT 18L evenly onto the formwork or storage surfaces. Avoid the formation of pools. |
| 2. | Clean all work equipment after use. |
If the product is applied with a spraying device, an oil-resistant model must be used.
IMPORTANT NOTES- Not water-soluble.
- Adhere to the specified application amounts.
SAFETY PROVISIONS/RECOMMENDATIONSFor detailed information regarding safety during transport, storage and handling, refer to the updated safety data sheet.
DISPOSALThe local waste removal regulations must be observed.
SPECIFICATIONSPackaging
Container size
Delivery form
Storage | PE canister
20 l
24 containers/pallet
18 months |