Weitere Marken von Sievert
Suche

INTRASIT® BLS 54TR

Drill hole suspension for shrinkage-free filling of cavities
CHARACTERISTICS
INTRASIT® BLS 54TR is a mineral filling mortar that hardens without shrinking and provides good flow characteristics and high permeability for injection liquids injected into existing brickwork.
It is resistant to water-soluble sulfates which are commonly found in masonry.
Due to its small grain size, it can be pumped with suitable pumping equipment.
  • Free-flowing
  • Non-shrinking
  • Sulphate-resistant
  • Easy to re-drill
  • Permits diffusion

INGREDIENTS
Standard cements, mineral aggregates, swelling agents, synthetic dispersion powder

    USE
    INTRASIT® BLS 54TR is used to fill cavities and drill-holes when sealing the interior of old cellars with chemical horizontal damp courses.

    Areas of application:

    • Outdoors and indoors
    • Masonry

    QUANTITY REQUIRED
    Per litre cavity volumeapprox. 1.8 kg


      1) At +20 °C and 60 % relative atmospheric humidity.APPLICATION
      The guideline is DIN 1053 for masonry design and construction.
      1.Slowly add INTRASIT® BLS 54TR to clear water in a clean mixing container while stirring it well until it becomes a homogenous, free-flowing paste that contains no lumps.
      Recommended mixing ratio:
      25 kg INTRASIT® BLS 54TR : 8.5 litres of water
      2.Use a funnel to pour the product into the existing drill holes within 45 minutes.
      3.Alternatively, INTRASIT® BLS 54TR can be injected with the aid of suitable pumping equipment. In this case, note the maximum grain size (max. 0.5 mm).
      4.Wait at least 2 days before re-drilling the area.
      5.Injecting the product with INTRASIT® VK 10A, INTRASIT® MEK 18OS or INTRASIT® BLK 18OS.
      6.After allowing the injection fluids to seep in continuously, mix INTRASIT® BLS 54TR with water to create a smooth paste.
      Recommended mixing ratio:
      25 kg -BLS 54TR : 7.5 litres of water
      7.Then fill the drill holes with the prepared paste and smooth flush to the wall.
      8.Wash all processing equipment with clean water immediately after use.


      When applying the produce at low temperatures, high air humidity or to damp masonry, you can accelerate the hardening process by adding a maximum of 5 % INTRASIT® Rasant 55Z.IMPORTANT NOTES
      • Not suitable for injection into cracks.

      SAFETY PROVISIONS/RECOMMENDATIONS
      Contains cement and will cause alkaline reactions when it comes into contact with moisture or water.
      Information regarding the safety during transport, storage and handling are included in the updated safety data sheet.

        DISPOSAL
        The local waste removal regulations must be observed.

          SPECIFICATIONS
          Packaging
          Container size
          Delivery form
          Application temperature
          Processing time1)
          Max. grain size
          Fully hardened1)
          Bending tensile strength
          after 28 days
          Compressive strength
          after 28 days
          Storage
          Paper bag
          25 kg
          30 sacks/pallet
          +5 °C to +35 °C
          approx. 45 minutes
          0.5 mm
          approx. 2 days

          1.2 N/mm2

          3.6 N/mm2
          dry, 12 months


            Produkty systemowe