INTRASIT^® SP 10A

USE
INTRASIT^® SP 10A is used for repairing existing masonry. It is applied over the entire area of the masonry affected by salts and efficiently reduces the migration ability of salts and prevent their penetration into fresh plaster.

Areas of application:

• Interior cellar sealing
• Masonry
• Plinth plaster repair

QUANTITY REQUIRED

Per application

approx. 0.5 kg/m2

PREPARATION OF THE SURFACE
Remove plaster damaged by salt and brittle joint mortar.
Thoroughly brush off masonry and dispose of residual mortar.
The masonry may be slightly damp.
Do not exceed a saturation dampness of max. 50 % in order to ensure sufficient penetration of the active ingredient.

APPLICATION
The guideline is DIN 1053 for masonry design and construction.

	1.	Apply INTRASIT® SP 10A generously with a brush or paintbrush.
	2.	After the surface of the solution has dried, a pneumatic bonding mortar and subsequently a repair plaster can be applied.
	3.	Wash all processing equipment with clean water immediately after use.

IMPORTANT NOTES

• Read the WTA information sheets.
• Please also read the brochure “INTRASIT^® remedial interior basement wall repair“.
• Not suitable for exposed masonry and facades.

SAFETY PROVISIONS/RECOMMENDATIONS
This is an alkaline product. Observe the usual hygiene procedures and precautionary measures when handling chemical products. If the product comes into contact with the eyes, rinse immediately with copious quantities of water and seek medical advice. Wear suitable work protection clothing.

DISPOSAL
The local waste removal regulations must be observed.

SPECIFICATIONS

Packaging Container size Delivery form Application temperature Density Storage

PE container 10 kg 40 containers/pallet +5 °C to +35 °C 1.1 kg/l frost-free, 18 months

• Safety data sheet
• Technical bulletin
• Brochure